CONSTRUCTION: Single-piece compression molded fiberglass reinforced polyester composite. Single-piece molded silicone gasket to prevent water, dust, and insect filtration. Fasteners are 300 series stainless steel. Two (2) ½" conduit inlets at bottom. Note: Watertight connectors and potting compound (by others) must be used to maintain a watertight seal at conduit entry points
FINISH: Composite is textured, pressure formed, molded-in-color
PANELS/LENS/GLOBE: Frosted borosilicate glass
LAMPING: 20W maximum T3 bi-pin lamp. Lamp is included with fixture. Higher wattages may be used only with glass panels installed
ELECTRICAL ASSEMBLY: Bi-pin socket type (G4) with 250° C high temperature teflon coated wire leads. 12 Volt fixture is pre-wired with 3-ft pigtail of 18-2 AWG, 105° C, SPT-1 wire. Low voltage quick connector, catalog #GLVC3 included for easy hook-up to the low voltage supply cable, not included. 12 Volt system requires remote transformer, not included
WARRANTY: Ten-year limited warranty
CERTIFICATIONS: ETL Listed to U.S. safety standards for wet locations. ETL Listed to Canadian safety standards for wet locations. Manufactured to ISO 9001:2000 Standards.